2 inch 6*139.7 wheel spacer for 2016- 2021 Toyota Tacoma 106 hub center M12*1.5 stud

FEATURES： 

These spacers will improve your vehicle’s stance and provide a more aggressive appearance while adding extra clearance for aftermarket brake and suspension parts. They also allow for the installation of larger wheel and tire combinations, giving you more customization options.

ADVANTAGE：

• HIGH-QUALITY MATERIAL：

High-strength 6061-T6 forged aluminum， while the 3000-ton forged T6 heat-treated plate body has high density, no pores, and no fear of plate cracking.

• ANODIZED SURFACE:

Further effectively improves the corrosion resistance and wear resistance of aluminum alloys.

• HIGH STRENGTH SCREWS:

The screw surface is treated with Dacromet, which is corrosion-resistant and rust-resistant. 12.9 level high intensity.

• SUITABLE:

It is centered on the wheel hub to ensure a perfect fit and precise wheel alignment.

• Effect:

By increasing the track width, wheel spacers can improve a vehicle’s handling and stability. Wheel spacers can push the wheels outward, giving the car a wider stance and a more aggressive appearance.

SPECIFICATIONS：

• Vehicle bolt pattern: 6*139.7
• Wheel bolt pattern:6*139.7
• Thickness: 50mm(2 inch)
• Hub bore: 106
• Thread size: M12*1.5
• Suggested Torque Spec:80-100 ft-lb
• Quantity: 4pc
• Material: Forged 6061 aluminum
• Design: hub-centric

COMPATIBILITY：

These spacers will bolt up to the following vehicles:

Toyota Tacoma 2016-2021
Toyota Tacoma SR5
Toyota Tacoma Limited
Toyota Tacoma TRD Sport
Toyota Tacoma TRD Off-Road

INSTALLATION:

• Step 1: Don’t use an impact wrench. Use a jack or lift to raise the vehicle so that the tires are in the air.
• Step 2: Remove the wheels/tires
• Step 3: Spray degreaser on lug studs It’s not required, but it’s a good idea. You want to make sure the wheel spacers are resting on a clean, smooth surface. If there is rust or corrosion, take a wire brush and clean it.
• Step 4: Put the wheel spacers in place Tighten by hand, but do not tighten the bolts. Just snap them all into place and tighten slightly.
• Step 5: Tighten the bolts according to the specification Once all the bolts are in place, use a torque wrench to tighten them to the manufacturer’s recommended specifications.
• Step 6: Reinstall the wheel onto the assembly/lug studs Secure and hand-tighten each lug nut before tightening them down. Tighten them in a star pattern to ensure the load is not applied unevenly.